M2. Rate

What It Is

The rate is how many seconds a day the watch would gain (+) or lose (−) if it kept running exactly as it does over the reading.

How It Is Worked Out

The app fits one straight line through the good beats’ times against their numbers:

time of beat k = t0 + P × k ± e/2
  • P is the watch’s beat period, the time from one beat to the next.
  • e/2 is added to Ticks and taken from Tocks: half the beat error, so the two sides’ uneven timing doesn’t tilt the line (M5).
  • The line is fitted by least squares, then fitted twice more without the beats over 5 robust standard deviations from it.

The rate compares P with the beat period the movement is made for, 3,600 s over the beat rate:

rate = (nominal period ÷ P − 1) × 86,400 s/d

An example. At 28,800 bph the nominal period is 125 ms. A watch gaining 10 s/d beats every 124.9855 ms: each beat comes about 14.5 microseconds sooner than the one before would suggest. Over 10 s, 80 beats, that adds up to 1.2 ms, which the fit can see.

Jitter, in the Rate card’s hover, is the robust standard deviation of the beats about the line, in microseconds: the spread of the dots across the strip.

Over several stretches, separated by breaks, each stretch is fitted on its own, and the rates are averaged weighted by the beats each used. A stretch whose beats span under 10 s gives no rate.

Why This Way

  • A line through every beat uses all of them. Timing one beat to the next would leave each rate at the mercy of two beats’ jitter.
  • The beat error in the line stops it from reading as a rate.
  • Dropping beats far from the line keeps a knock or a mis-found beat from pulling the rate.
  • No line across a break: after a pause, a jump or a turn of the watch, the beats’ count and phase don’t carry on, and the watch may have changed.

When You’d Use It

  • Regulating: read the rate in each position you regulate in, with Average Over long enough to steady the last digit.
  • Comparing positions: the Positions Test reads one rate per position (chapter 20).
  • Following a change: a short Average Over shows the rate move as you turn the regulator.

What It Helps Find

  • Positional error: rates that differ between positions.
  • A rate that drifts as the mainspring runs down, or swings as a wheel turns (the Steadiness panes).
  • Jitter much above the take’s usual shows a poor sound, a stand noise, or a watch whose timing is genuinely uneven.

What It Can’t Tell You

  • The rate on the wrist. It changes with position, wind and temperature. A reading is one position, at one state of wind.
  • The sound card’s error. The rate is measured on the sound card’s clock, which is commonly 1 to 4 s/d off. See M3.
  • A rate between beats. The fit can’t see changes faster than its span, the Average Over time.

Previous: M1. Beats · Next: M3. The Sound Card’s Clock

This page comes from the app's user guide at v1.0.1. See it on GitHub.